Weifang Fred Machinery Co., Ltd.
Weifang Fred Machinery Co., Ltd.
Add to Cart
6 Inch Wood Chipper With Direct Drive System To Match 30 - 100HP Tractor
The hydraulic feed chipper runs 2 support strong arms to each side of the hopper with a hydraulic motor on each side, many similar looking hydraulic chippers only run a single sided support arm that resualts in the mount twisting through constant load and vibrations.
The horse power range is from 30hp - 100hp, tractors in the lower end of this rang will struggle operating at the full 6" capacity when chipping hard woods, knots etc., slowing down the feed speed will help smaller tractors work efficiently.
It runs a direct drive from the PTO shaft without the need for gears or belt drives.
Many chipper on the market are far too complicated and a simple job such as replacing blades can be very difficult. The hays PTO chipper gains complete access to the rotor for servicing by removing one bolt and the top half of the housing opens for easy access. The hopper can also be fully opened by removing only 2 bolts and nuts.
We offer different chippers with our hydraulic feed and they all feed extremely well. The benefit of the hydraulic model is the feed speed can be made faster or slower that it can chip at a speed that the out shoot can handle.
Using the hydraulic feed model there is less preparation work cutting branches to feed as the dual barrel feed rollers with drag the branches in and this is a great help when chipping the heads of trees.